contact usContact Us
Changzhou Chaokang Machinery Co., Ltd. Contact: Ge Lei Phone: 18068771880
Factory Address: Anjia Industrial Park, Chunjiang Town, Xinbei District, Changzhou Office Address: Room 1513, Building 4, Tianyu Plaza, Xuejia Town, Xinbei District, Changzhou, Jiangsu
The packing layer in the PP waste gas tower is used as a mass transfer device for the gas-liquid two-phase contact member. A packing support plate is installed at the bottom of the packing tower, and the packing is placed on the supporting plate in a random manner. A packing pressure plate is installed above the packing to prevent it from being blown by the updraft. The spray liquid from the spray tower sprays from the top of the tower to the filler through the liquid distributor, and flows down along the surface of the filler. The gas is sent in from the bottom of the tower, and after being distributed by the gas distribution device, it passes through the gap of the packing layer in a countercurrent flow with the liquid. On the packing surface, the two phases of gas and liquid are in close contact for mass transfer.
When the liquid flows downward along the packing layer, a wall flow phenomenon sometimes occurs. The wall flow effect causes the gas and liquid phases to be unevenly distributed in the packing layer, thereby reducing the mass transfer efficiency. Therefore, the filling layer in the spray tower is divided into two sections, and a redistribution device is arranged in the middle to spray on the lower filling layer after redistribution.
In order to enable the spray tower to reduce failures, prolong its service life, and improve its purification efficiency, we must strictly follow the requirements during use, and need to do the following:
1. Regulation of circulating water volume: It is determined by the spray tower water supply pump. When one boiler is running, one can be turned on. When two or three are running at the same time in winter, both water pumps are turned on, and the mud pump is at its flow rate. It should be adjusted according to the flow of the circulating pump to make them equal.
2. Dosing volume in the dosing tank in the spray tower: When operating a boiler, add 2 bags of alkali and 5 bags of slaked lime. If two or three units are operated in winter, the dose can be increased by a corresponding multiple.
3. The spray tower sedimentation tank should be cleaned frequently, once a week in summer and once every three days in winter.
4. When the gray water separator discharges sewage, it is discharged once per shift, and the sewage valve should be opened separately until clear water is discharged.
5. The above rotating parts should be frequently checked and filled with oil, and the faults should be eliminated in time to ensure the desulfurization effect of the spray tower.
6. Pay attention to safety when adding medicine on the stairs and down stairs, and have independent security and mutual security awareness.
7. After the work is completed, the sanitation should be cleaned up in time so that people can clear the site.
You might also be interested in